Specification description

Audio Amplifier :

• Peak 2 x 80 W sine 1 kHz (RMS)

into 4 Ω (10 %THD + N)

• Peak 2 x 40 W sine 1 kHz (RMS)

into 8 Ω (10 % THD + N)

• Continuous 2 x 9.0 W sine 1 kHz (RMS)

into 4 Ω (less than 0.02% THD + N)

• Under-voltage-lockout

• Over-temperature warning/error

• Short-circuit/overload protection

• Power stage pin-to-pin short-circuit

• Error-reporting through serial interface (I2C)

• DC protection

• I2C control (four selectable addresses)

• Heatsink free operation with EPAD-down package

Type-C:

• Fixed-function USB Type-C and Power Delivery controller supporting USB-PD Rev 3 and Type-C Rev 1.2

• Integrated precision Rd and dead-battery Rd termination resistors

• Integrated regulator to power from VBUS

• Supports a high-voltage P-MOSFET gate driver with slew-rate control

• Supports on-chip OVP and UVP to protect system from faults

• System level ESD protection on CC, VBUS, DP and DM pins. ±8kV Contact Discharge and ±15kV Air Gap Discharge

• based on IED61000-4-2 Level 4C

 Bluetooth:

• Bluetooth 5.0, ADC, PWM, UART, I2C, SPI

• Module size: 12.00 mm × 15.50 mm × 1.95 mm

• Bluetooth 4.2 Smart Ready module

• Castellated solder pad connections for ease-of-use

• 512-KB on-module serial flash memory

• Up to 11 GPIOs

• Temperature range: –30 °C to +85 °C

• Cortex-M3 32-bit processor

• Maximum TX output power:

• +12 dBm for Bluetooth Classic

• +9 dBm for Bluetooth Low Energy

• RX Receive Sensitivity:

• –93.5 dBm for Bluetooth Classic, 1Mbps, GFSK

• –96.5 dBm for Bluetooth Low Energy

• Certified to FCC, ISED, MIC, and CE regulations.